Genuine FT232RL usb cable for Rover MEMS 1.3, 1.6 (Mini, Metro, MG, Land Rover, etc) OBD Diagnostic Cable Original FTDI USB cable to 3pin
READ & ERASE FAULT CODES
TEST ACTUATORS FOR FAULTS
(AC RELAY, PTC MANIFOLD HEATER RELAY, FUEL PUMP RELAY, FUEL INJECTOR, IGNITION COIL)
CHECK ENGINE SENSOR PARAMETERS FOR FAULTS ON A TEST DRIVE
Rover MEMS 1.3 and 1.6 OBD Diagnostic usb Cable, this cable is with genuine Original FTDI FT232RL chip, not the versions with fake chip inside which only partrial working.
This is essentially to replace/replicate the functions of the older tools such as the Sykes Pickavant ACR 4 diagnostics.
This is to suit cars with the white/cream round 3-pin diagnostic connector in the engine bay, pls check carefully before you place an order, it is good for you!
Tested already and suitable for SPI Minis, SPI Metros and even some early MPI cars (with the round diagnostic connector) e.g. MGF!
This is working with MEMS 1.3 and MEMS 1.6 version ECUs
This link is only for: THE DIAGNOSTIC LEAD, ANY PROBLEMS OR QUESTIONS WITH THE SOFTWARE
PLEASE EMAIL THE SOFTWARE DEVELOPERS OF MEMSGUAGE OR MEMSANALYSER AS IT IS NOT MY SOFTWARE AND I CANNOT ANSWER ANY QUERIES ABOUT IT.
Pls note: we do not offer any software or any software or copyright for it we mentioned is just for reference.